RAPTURE ALTAR 200, Руководство пользователя, Страница: 4 / 20

ENGLISH 4
USING THE CONTROL PANEL
Plug the end of the control panel cable into the input port
in the desk.
Reset
If you are using the control panel for the first time or if
you have not used it for a long time, we recommend that
you reset the system before using it again.
1. Disconnect the control panel cable end from the
input port. Plug it back in after 10 seconds.
2. Press and hold the down. It is important that you
hold the button down throughout the control panel
reset. The desk will slide to the lowest possible
height and after 5 seconds the display will show
”
rSt ”. Then the desk goes down to the really lowest
position, and then rises a little.
3. An alert sounds and the reset process is success-
fully completed.
Setting the height of the desk
The
up/down buttons are used to change the height of
the desk.
1. The display shows the actual height of the desk
both during the adjustment and in rest state.
2. Press and hold the up/down button to raise/lower
the desk to the required height smoothly.
3. Press briefly the up/down button to raise/lower the
desk by 3 mm.
4. The desk movement will automatically stop once
you reach the maximum or minimum height.
Note: Charging is paused while you adjust the desk’s
height. Once the height adjustment is complete, the
charging process will automatically resume.
Presets
1. Set the desired desk height. Press the
M button and
the display shows " S- ”. Then press the button 1 or
2 and the display shows " S-1 ”/” S-2 ”. This indi-
cates that the desk’s height is saved to the selected
preset. Wait 5 seconds for the data to be saved. The
display shows the current height of the desk.
2. Press the button 1 or 2 and the desk’s height auto-
matically adjusts to the saved height. The display
will show the height of the desk. Press any button to
stop the movement of the desk.
Control panel lock
1. If you want to prevent an accidental adjustment
change, press the M button for 3 seconds to lock
the control panel. The display shows: “---”.
2. Press the M button for 3 seconds to unlock the
control panel. The display shows the current height
of the desk.
Power save mode
If you do not press any button for 10 minutes, the control
panel will go into power saving mode. The display goes off.
1
3
2
4
5
6
7
8
9
1. Display Shows the desk height and other additional functions
2. RGB backlight
3. Up/Down buttons Setting the desk height upwards/downwards.
4. M button Enter a selection of preset 1 or 2
5. Preset 2 Adjusting the height of the desk to one of two user-stored positions
6. Backlight control button
7. Preset 1 Adjusting the height of the desk to one of two user-stored positions
8. USB-A port 18 W rechargeable USB-A port
9. USB-C port 18W rechargeable USB-C port with QC fast charging support
OVERVIEW