Rapid EG PEN, Руководство по эксплуатации

Страница: 13 / 144

13
melted glue.
5. To prevent clogging of this glue pen, keep feeding mechanism and
melt chamber free from dirt and other foreign debris.
6. Make sure the stand is placed in safe position on the work area, not
close to temperature sensitive materials or close to the edge of the
work area to avoid incidents. (Figure 2)
7. Store unused glue sticks in a clean environment.
8. Do not pull glue stick from the back of the glue gun. The feed
mechanism may be damaged or impaired. If you need to change
glue type, cut off the protruding end and feed the remainder through
with the new glue stick.
9. Do not place the heated glue pen on its side on any heat sensitive
material, place the glue pen in a designated stand or on a work-
bench.
10. If melted glue has escaped from the melt chamber entrance and is
interfering with the feed mechanism; allow gun to cool, and gently
remove the obstructing glue.
11. Do not use glues other than those recommended by Rapid.
12. Leaving the tool on for too long without use can lead to risks. Un-
necessary overheating over a long period of inactivity, without use,
depending on the length of time and type of glue used, can have
adverse effects.
13. Once finished, disconnect the cord from the socket.
In any case, you should never:
1. Force the trigger before the tool has heated up to its wor-
king temperature
2. Push hard on the glue stick, never attempt to remove it from the
back.
3. Repair the glue pen, any repair work on the glue pen should be
carried out by manufacturer or other by Rapid appointed staff.
4. If the supply cord is damaged, it must be replaced by the manu-
facturer, its service agent or similarly qualified persons in order to
avoid a hazard.
Maintenance