Rapid Packaging Eagle R2B2, Руководство по эксплуатации

Страница: 38 / 50

- 38 -
5.3 Alarm Codes
Alarm
Code
Trouble Cause Solution
M311 Emergency Stop
(EMG STOP) 1) E-Stop button is pressed
on the control panel.
2) E-Stop button is pressed
on the steering arm. Reset E-Stop
M311 Safety Bumper Safety switch making contact
with an object Move the object
M312 Not Ready / Press Reset Machine displaying error
message Review error message and
press reset after clearing
message.
M313 Charging Machine is plugged in Unplug the machine from
power source
M316 Film out or broken Film supply has been
exhausted or film broken Replace with new roll of film
or rethread film
M317 Film Carriage Not Down Carriage must be at the
bottom position to start in
auto mode Press Reset then Start
M321 Film Tear Failure Film attached to pallet Cut film manually
M322 Low Battery Battery charge levels have
dropped too low Recharge batteries
M333 Machine motor shorted to
battery 1) Short circuit
2) Motor failure 1) Repair/Replace motor
wiring
2) Replace motor
M334 Machine motor overload Machine has run into an
object Move the object
M338 Motor or wiring problem Forward motor wire is broken
or loose Check the motor wiring
between forward motor and
controller
M339 Controller or wiring
problem Controller failure 1) Cycle power to machine
2) Replace controller
M340 Machine is in motion and
over speed limit 1) Machine was pushed
during operation
2) Machine operating on a
non-level surface Cycle power to machine
M341 Machine alarm requires an
E-Stop activation Forward speed controller
error detected Cycle power to machine
M343 Carriage motor shorted to
battery 1) Short circuit
2) Motor failure 1) Repair/Replace wiring to
carriage
2) Replace motor