Rapid Engineering CTHN-40, Руководство по установке и эксплуатации

Страница: 50 / 100

CTHN-S
ERIES
I
NSTALLATION
, O
PERATION AND
S
ERVICE
M
ANUAL
44 of 91
Step 9.11.1 Reflector, U-clip and Reflector Support Installation
The pictorial dra w ings of the heater constr u ction in
Section 9 are schematic only and provide a general
g u ideline of w here hangers, reflector s u pports and
u -clips are to be installed.
To ens u re proper expansion and contraction
movement of the reflectors, a combination of u -clips
and reflector s u pports are u sed. The positioning of
reflector s u pports and u -clips depend on the
individ u al installation. Use either pop rivets or sheet
metal scre w s instead of u -clips w hen installing end
caps and joint pieces in areas w here impact and high
w ind may be a factor. The follo w ing r u les m u st be
observed.
2. The overlap at the first and second reflector is a slip overlap.
Thereafter, every third reflector joint is a slip overlap. A slip
overlap is achieved by either:
a.) both reflectors lay inside a hanger.
(No reflector support needed.)
b.) using a reflector support with
loose screws at the reflector
overlap.
3. The remaining reflector overlaps require a non-slip
overlap connection. To affix the reflectors together in
a non-slip overlap either:
a.) use reflector support and tight screws.
b.) if both reflectors lay inside a hanger, u-clips or
sheet metal screws may be used.
This section of three reflectors joined together must
be affixed to the tube with at least one reflector support
with tight screws.
Reflector
End Cap
U-clips
1. The first reflector after the burner must be affixed in
the middle of the reflector with a reflector support and
tight screws.
First Reflector
6"
(16 cm)
Overlap must be a
minimum of 6" (16 cm).
Loose screws
loosened 1/16"
(.16 cm) to allow
slippage.
2 A
Slip Overlap
Reflector
Support
2 B
Slip Overlap
Reflector
Tight
Screws
3 B
Non-Slip Overlap
U-clip
(2 Clips per
Non-slip Overlap
Inside a Hanger)
Reflector
3 A
Non-Slip Overlap
Wire Form
Reflector Support
Strap
Tight
Sheet Metal
Screw
Description Part Number
Reflector Support Package 03050010
Wire Form 91908004
Reflector S u pport Strap 03050000
Scre w #8 x 3/4 94320812
U-clip Package 91107720
Reflector End Cap 027508XX