Ransomes HIGHWAY 2130, Руководство по безопасности, эксплуатации и техническому обслуживанию, Страница: 23 / 132

en-21
RANSOMES HIGHWAY 2130
SAFETY AND OPERATORS MANUAL
6 CONTROLS
6.1 STARTER KEY SWITCH
The starter key (A) should be turned clockwise to
the 'pre-heat' (No. 2) position to heat the glowplugs
when the green warning lamp goes out on warning
lamp disply module turn the starter key clockwise to
the 'start' (No. 3) position to start the engine. After
starting, the key should be released and allowed to
return automatically to the 'on' (No. 1) position for
normal running. Where fitted the rotating beacon is
turned on when the key switch is in position No. 1
6.2 THROTTLE CONTROL LEVER
The lever (B) should be moved away from the
operator to increase the engine speed and towards
the operator to decrease the engine speed.
NOTE: Engine should be used at full speed.
6.4 TRACTION FOOT PEDAL
To move the machine forward press the front of the foot
pedal (A). To reverse depress the rear of the foot pedal.
When the pedal is released it will return to its neutral
position.
6.5 SPEED LIMITER
The speed limiter (B) is operated by sliding the
black knob to the right or left. When slid to the right
the machine is limited to cutting speed, when slid to
the left, transport speed is available. In transport
mode, reverse is not available. When the speed
limiter is in the mow speed position four wheel drive
is engaged.
IMPORTANT: To enable mow engage the speed
limiter must be in the cutting speed position. If
cutting units are rotating, moving the speed
limiter between the mow and transport
positions will engage and disengage cylinder
rotation.
6.3 STEERING WHEEL RAKE ADJUSTMENT
The steering wheel is adjustable for rake. The
clamping release knob (A) is situated on the side of
the control console on the right hand side. To adjust
turn the clamping knob anticlockwise to release and
pivot the steering wheel backwards and forwards to
obtain desired setting then lock in position by
turning clamping knob clockwise.