2. Remove fluid tube.
3. Pull barrel away.
Remove/Replace Cascade
1. Pull cascade straight out.
2. Carefully disconnect harness by pulling connector
on both sides by hand and rocking it side to side
to remove.
3. Replace cascade as necessary.
4. Apply LSCH 0009 grease to end of cascade.
CAUTION
!
Do not pull with excessive force or twist
wires. This could damage casscade connector
or wire harness.
5. Re-connect harness by pushing down to snap.
6. Re-install cascade into handle.
AH-15-01.2
31
Ranflex Applicators
-
MAINTENANCE
