GENERAL DESCRIPTION
The Ransburg 9060 High Voltage Controller
(80180-
212) is used to provide high voltage for electrostatic
application equipment. It uses a combination of
proven high voltage generation technology and
microprocessor-based control. It uses a variable
voltage output to drive a cascade that amplifies
the voltage to a high kV level. It also uses current
feedback information to maintain the desired set
point. The processor circuitry provides the maximum
in applicator transfer efficiency, while maintaining the
maximum safety.
The 9060 Controller selection and adjustment of set
point values is performed from the controller front
panel. The triggering of the HV is normally initiated by
the airflow switch built into the controller which senses
airflow triggered by a standard handgun.
SAFETY FEATURES
When used with the appropriate applicators and
cascades, the Ransburg 9060 High Voltage Controller
provides maximized operational safety. The protections
include detection of Boot Faults, Ground Faults, Cable
Faults, Feedback Signal Faults, Overvoltage, and
Overcurrent. The microprocessor circuits provide a
controlled output load curve, which limits the high
voltage output to safe levels while monitoring control
and feedback signals for unsafe conditions. Maximum
operational safety is obtained when the correct
applicator settings are used and when safe distances
between the applicator and target are observed and
followed. The maximum efficiency of the high voltage
controller is based on load.
DISPLAYS
The front panel displays the high voltage set point
as well as a reading of gun current output. The gun
current is derived from feedback signals between the
controller and the cascade.
Figure 1: 9060 High Voltage Controller (HV3)
80180-212 Vector R70AS Handgun
INTRODUCTION
9060 HIGH VOLTAGE
CONTROLLER
Description
Part #
CP-17-02
6
9060 Classic High Voltage Controller -
INTRODUCTION
