Ransburg 77070-33, Руководство по обслуживанию

Страница: 6 / 40

CP-08-01
9040 Classic HV Power Supply - Safety
3 3 3 3 3
A R E A A R E A
A R E A A R E A
A R E A
Tells where hazards
may occur.
H A Z A R D H A Z A R D
H A Z A R D H A Z A R D H A Z A R D
Tells what the hazard is.
S A F E G U A R D S S A F E G U A R D S
S A F E G U A R D S S A F E G U A R D S S A F E G U A R D S
Tells how to avoid the hazard.
Spray Area Spray Area Spray Area Spray Area Spray Area Electrostatic Arcing Ensure the ground wire assembly is connected from the
power supply ground stud to a true earth ground.
Ensure that the power supply is plugged into a properly
grounded outlet.
If shocks or sparks are noticed at any point in the spray
system, immediately turn off the power supply and check
the complete system for the cause. DO NOT use the
system again until the problem has been identified and
corrected.
Never operate the applicator without properly grounding the
following:
A. Operators Operators Operators Operators Operators must be grounded. Rubber soled
insulating shoes should not be worn. Grounding
leg straps may be used.
Operators must maintain contact with the handle of
the applicator. If work gloves are used, the palm
section should be cut out.
Operators must remove from themselves all metal
objects that are not grounded.
B. Parts being sprayed. Resistance between the part and
a grounded conveyor must not exceed 1 megohm.
C. Every metal and conductive object in the spray
area. This includes the booth, parts hangers, fire
extinguishers, conductive flooring, etc.
Grounded conductive flooring must be provided in the
spray area.
Turn off voltage at the power supply before flushing out,
cleaning, or removing any parts from the applicator.
Provide proper protection for waterborne supply systems.
Never install an applicator into a fluid system using an
isolated solvent supply.
Always discharge waterborne system capacitance prior to
servicing.
Do not touch applicator electrode while applicator is
energized.
ARCHIVE