Rankam ST1017-012939, Руководство оператора

Страница: 16 / 24

P 16
Connect the regulator assembly to the tank valve and HAND
TIGHTEN nut clockwise to a full stop. DO NOT use a
wrench to tighten because it could damage the Quick
Coupling Nut and result in a hazardous condition.
Open the tank valve fully (counterclockwise) and use a
soapy water solution to check all connections for leaks
before attempting to light your grill. See “
Checking for LP
Gas Leaks ”. If a leak is found, turn the tank valve off and do
not use your grill until the leak is repaired.
CAUTION: When the appliance is not in use the gas
must be turned off at the tanks.
Check all connections for LP Gas Leaks
Never test for leaks with a flame. Prior to first use, at the beginning of each season, or every
time your LP Gas tank is changes, you must check for gas leaks. Follow these three steps:
Make a soap solution by mixing one part liquid detergent and one part water.
Turn the grill Control Knobs to the full OFF position, then turn the gas ON at source.
Apply the soap solution to all gas connections indicated by the arrows. See diagram. If
bubbles appear in the soap solution the connections
are not properly sealed. Check each fitting and tighten
or repair as necessary.
If it is evident there is excessive abrasion or wear, or
the hose is cut, it must be replaced prior the appliance
being put into operation. The replacement hose
assembly shall be that specified by the manufacturer.
WARNING
If you have a gas leak that cannot be repaired by tightening, turn off the gas at the source,
disconnect fuel line from your grill and call your gas supplier for repair assistance.
Never disconnect the gas regulator or any gas fitting while your grill is lit. A lit grill can ignite
leaking gas and cause a fire or explosion which could result in property damage, personal
injury or death.
Disconnecting a Liquid Propane Gas (LPG) Tank From Your Grill
Make sure the Burner Valves and LP Gas tank valve are off. (Turn clockwise to close.)
Detach the hose and regulator assembly from the LP Gas tank valve by turning the Quick
Coupling Nut counterclockwise.
! !