14
Aldis
Tutor
II
Service
©M.Ginda
08/02/2008
WWW.Karillon.com
Using a xpoint screwdriver, adjust the two lamp holder screws to obtain the
pattern. Be careful not to undo the screws completely. Small adjustments of
the screws are all that is usually required, check the lamp is fully seated and
vertical if you have difficulty obtaining the pattern.
Once completed, the lamp cover can be fitted in place and then the main
projector outer cover can be fitted.
Check that the two front feet adjust correctly, apply a little oil to the threads,
remove the alignment card and keep it safe for further use.
Enjoy using your serviced projector.
Replace faulty lamps with type M33 24v 250w
Occasionally remove the outer cover and remove dust and dirt using a brush.
Regularly clean dirty lens parts. (Full Disassembly is not required for this).
