Ranger RP-20FC, Инструкция по установке и эксплуатации

Страница: 9 / 20

RP-20FC Oil Filter Crusher
9
P/N 5900011 — Rev. B1 — February 2021
Assemble the Stand
The Stand comes disassembled (to protect the components during shipping).
The following graphic shows the components of the Stand.
To assemble the Stand :
1. Arrange all of the Stand components near where you are going to assemble it.
2. Lay the Top flat on the ground, with the inside facing up.
3. Attach the Top Lefts (2) and Top Rights (2) to the Top using the included M6 Bolts, M6 Washers,
Split-Lock Washers and M6 Nuts.
Important : The Legs look similar but they are
not
interchangeable. The Top pieces are different
from the Bottom pieces and the Left Legs are different from the Right Legs. We
recommend laying them out to make sure you have the right sections in the right
places
before
connecting them.
4. Connect a Small Leg (4) to each Leg, and then connect the Bottom Lefts (2) and Bottom Rights (2)
to the corresponding Legs.
5. Attach the Top Supports (2) and Bottom Supports (2) to the Stand.
6. Attach the Diagonal Leg to the top of the Stand, put the Stand Support in place near the bottom of
the Stand, and then secure the bottom end of the Diagonal Leg (1) and Side Supports (2) in place.
7. Move the Stand to the upright position.