Ranger RP-20FC, Инструкция по установке и эксплуатации

Страница: 12 / 20

RP-20FC Oil Filter Crusher
12
P/N 5900011 — Rev. B1 — February 2021
Operation
This section describes how to use the Oil Filter Crusher safely during normal operation.
Safety Rules
Important : Your safety is dependent on reading, understanding, and implementing these Safety
Rules. Do not skip over them, read them carefully and follow them .
To use your Oil Filter Crusher safely :
• Before crushing an Oil Filter, inspect the unit. Check for worn or missing part, loose connections,
or any other abnormalities.
• Only allow trained, supervised personnel to operate the Oil Filter Crusher.
• Do not smoke while using the Oil Filter Crusher.
• Do not try to open the Door while an Oil Filter is being crushed.
• Other than the Technician operating the Oil Filter Crusher, keep all other people a minimum of 30
feet away from the unit while it is being used.
• Only put one Oil Filter in the Crusher at a time.
• Avoid off-center loads. If the press ram seems to be laboring more than usual or the filter/can is
unusually hard to press, stop operation. Do not operate the press ram if the filter/can tilts or binds
during the downward movement of the press head.
•
Do not leave the Oil Filter Crusher with the Press Ram down; always complete the crushing cycle.
• Pay attention at all times while using the Oil Filter Crusher. Safety is your top
priority at all times.
To operate your oil filter crusher :
1. Connect the air supply to the Air Fitting and turn the air supply on, a minimum of 125 – 175 psi.
2. Place an approved waste oil container under the oil drain (on the underside of the Enclosure Base).
3. Open the Door and place an empty filter or paint can in the center of the chamber,
open end
down
.
4. Close and lock the Door.
⚠
CAUTION
You cannot crush an item until the sliding door is fully closed.
5. To begin operation, turn the Control Handle to the Left .
⚠
WARNING Once the Press Ram makes contact with the item, step away as far as possible
until the procedure is complete.
6. To remove the crushed filter, turn the Control Handle to the Right .
The air will exhaust from the press cylinder and the Press Ram will rise.
⚠
WARNING Do not open the door while the unit is operating; you must wait for the press to
cycle completely.