Ranger Laser-Spot LS43B, Инструкция по установке и эксплуатации

Страница: 33 / 64

LS43B Laser-Spot™ Wheel Balancer
33
P/N 5900086 — Rev. A1 — 12/212018
Dynamic Balancing
Dynamic Balancing balances a Wheel on both the Inner and Outer Edges.
If the Wheel is out of balance, the Clip-On Weight can go on the Inner Edge, the Outer Edge, or both.
To Balance a Wheel using Dynamic Mode
:
1. Make sure you are wearing ANSI-approved eye protection: safety glasses, face shield, or goggles.
2. Visually inspect the Balancer to make sure everything is in place. The Hood should be
up
.
3. Make sure the Wheel you want to balance is both clean and free of any weights that may have
been put on previously, then mount it.
Refer to
Mounting a Wheel
for mounting instructions, if needed.
4. Turn the Balancer Off and then back On, to reset it.
On power up,
bal 11 will appear in the Inner and Outer Windows, followed by default Wheel
dimensions.
5. Pull out the Inner Arm and place it against the Inner Edge of the Wheel (where the inner weight will
go) and hold it there;
wait for the Balancer to beep
.
6. When the Balancer beeps, return the Inner Arm to its normal location.
The Inner Window shows the Distance from the edge of the Balancer to the Inner Edge.
The Inner Window always shows distances in millimeters (mm) because the Distance Ruler on the
Inner Arm displays only millimeters.
7. Place the tip of the Outer Arm on the Outer Edge of the Wheel (where the outer weight will go) and
hold it there;
wait for the Balancer to beep
.
8. When the Balancer beeps, return the Outer Arm to its normal location.
The Outer Window shows the Diameter of the Wheel.
The Outer Window shows distances in millimeters (mm) or inches (in). Press the
mm inch button
on the Control Panel to switch between them.
If you check the Mode indicators, you will see that DYN (Dynamic Mode) is lit.
A value also appears in the Width Window; it is determined automatically.
The Balancer now has enough information to perform a Dynamic Balance of the Wheel.
9. Lower the Hood; the Wheel spins briefly.
10. When the Wheel stops, look at the values that appear in the Inner and Outer Windows on the
Display Panel; these amounts show you how unbalanced each plane is.
The measurement system, grams or ounces (the default), is lit under the Inner and Outer Windows.
To switch between grams and ounces, press and hold Stop , then press Distance
+
.