Ranger Laser-Spot LS43B, Инструкция по установке и эксплуатации

Страница: 13 / 64

LS43B Laser-Spot™ Wheel Balancer
13
P/N 5900086 — Rev. A1 — 12/212018
Unpacking
Use caution when unpacking the Balancer from its shipping container. You do not want to damage the
unit, misplace any of the components that come with it, or hurt anyone.
⚠
CAUTION Make sure to use an appropriate lifting device, such as a forklift or pallet jack, to
move the Balancer while it is on its pallet. Make sure only personnel who are
experienced with material handling procedures are allowed to move the Balancer.
The Balancer is heavy and the weight is not evenly distributed; dropping or
knocking over the unit may cause equipment damage or personal injury. Do not lift
the Balancer by the Shaft Housing; it is not strong enough for that.
We recommend you unpack the Balancer in the area where you are going to set it up.
To unpack the Balancer :
1. Remove the carton by flipping down the metal tabs at the bottom and pulling off the top.
2. Remove the shipping bolts that are holding the Balancer to the Pallet.
3. Remove the straps and plastic wrap that held the Balancer components during shipping.
4.
Lean the Balancer over and reach underneath it
to pull out the Accessory Box .
5. Move the Balancer off the Pallet, then move it to the desired location.
Important
: Do not lift the Balancer by the Shaft Housing; it is not strong enough to bear the
weight of the Balancer.
⚠
CAUTION Ranger recommends having at least two people move the Balancer; it is heavy. If it
is dropped or falls, it could cause injuries and/or the Balancer could be damaged.
Components on the Back of the Balancer
The Balancer has multiple components on the back that need to be installed.
Balancer components on the back include:
•
Display Panel Mount Bar
. Holds the Display in place. Connects to the back of the Balancer via
the Display Panel Base Plate, which is at one end. The Display attaches to the other end.
•
Mount Box
. Connection point for the Hood Mount Bar and the Outer Arm Mount Bar. Connects
to the back of the Balancer.
• Hood Mount Bar . Holds the Hood. Connects the Hood to the Mount Box.
•
Outer Arm Mount Bar
. Holds the Outer Arm. Connects the Outer Arm to the Mount Box.