Ranger Laser-Spot LS43B, Инструкция по установке и эксплуатации

Страница: 28 / 64

LS43B Laser-Spot™ Wheel Balancer
28
P/N 5900086 — Rev. A1 — 12/212018
Controlling the Balancer using the Control Panel
The Control Panel is used to control aspects of the Balancer during both the Measurements phase
and the Weights phase.
•
Distance, Width, Di / — buttons . Used to change the Distance, Width, and
Diameter settings during the Measurements phase of the balancing session (before you spin the
Wheel). Only needed if you want to enter these values manually; otherwise, use the Inner Arm and
Outer Arm to have the LS43B determine these values automatically.
•
C button
. Used for calibrating the Balancer.
Important : The Balancer comes from the factory already calibrated . There is no reason to calibrate
it again when you first receive it. You only need to calibrate it if you are seeing multiple
bad balances.
• T button . Performs a test of the Balancer software.
• F button . Switches between Dynamic and Static Modes.
•
mm / inch button
. Lets you toggle between millimeters (mm) and inches for those windows that
show these measurements.
To switch between grams (g) and ounces (oz) when a window shows appropriate values, press
and hold
Stop and then press the Distance
+
button.
• ALU button . Press to switch between Dynamic Mode and the three ALU Modes.
• OPT button . Used with the Optimize Function.
• <5g button . Press and hold to see exact unbalance values. Otherwise, the Balancer rounds off.
• Start button . Starts the Wheel spinning, which can also be done by lowering the Hood.
• Stop button . Stops the Wheel from spinning and releases the automatic brake when you have
added weight to the Inner Plane and want to move on to the Outer Plane.