Ranger DST30P, Инструкция по установке и эксплуатации

Страница: 25 / 60

DST30P Wheel Balancer
25
P/N 5900163 — Rev. C1 — March 2020
• Balancing Mode indicators . STA 1, STA 2, ALU1, and ALU2. When a Balancing Mode is
selected, the appropriate indicator to the left lights up. If
none
of the four indicators is lit, then
Dynamic Mode is active.
Put another way, there is no indicator for Dynamic Mode. When no indicators are lit, which is the
default when the Balancer is switched on, Dynamic Mode is active.
The Balancing Mode indicators also have diagrams to show where the weight goes when it is
necessary to add weight. The diagrams are different for each Balancing Mode.
The red dots indicate where the weight goes for each Mode.
•
Start button
. Starts the Wheel spinning, if the Hood is down. By default, lowering the Hood
starts the Wheel spinning. To disable this, press Stop and then press the R button. Press Stop and
R again to re-enable.
• Stop button . Stops the Wheel from spinning.
⚠
WARNING
In an emergency, the fastest way to stop the Wheel and the Shaft is to press the
Stop button and press down on the Brake Pedal.
• Distance, Width, and Diameter diagrams . Located just above the Plus and Minus buttons,
they are visual representations of how you measure the Wheel to get the necessary information:
–
Distance . Distance from the side of the Balancer to the Inner Edge of the Wheel.
–
Width
. Width of the Wheel from the Inner Edge to the Outer Edge.
– Diameter . Diameter of the Wheel at the Rim.
See About Measurements for more information.
• Plus and Minus buttons . Press to increase the value (Plus button) or lower the value (Minus
button). One set for each column: Distance, Width, and Diameter.
• F button . Press to switch between Balancing Modes.
• R button . Used with Stop button to toggle Auto Hood Start.
• <5g button . By default, the Balancer shows values for Weight needed rounded to .25 ounce /
7 grams. If you want to see Weight values at a more granular level, press and
hold <5g
.
Weight values are shown not rounded off while you press and hold
<5g
.
For example: