Ranger DST30P, Инструкция по установке и эксплуатации

Страница: 17 / 60

DST30P Wheel Balancer
17
P/N 5900163 — Rev. C1 — March 2020
6. Locate the Hood Mount Arm and the Hood.
7. Starting with the bottom of the Hood Mount Arm , slip the hole at the bottom over the
Shaft on the left side of the Hood Mount Box. The Shaft is shown in the drawing on the previous
page.
Orient the Hood Mount Bar so that the Bumper goes up against the back of the Balancer.
8. Align the Set Screws on the bottom of the Hood Mount Arm with the Grooves in the Shaft, then
tighten the Set Screws.
Important
: The Set Screws need to be tightened down into the Grooves in the Shaft or the
Hood will not work correctly.
Not necessarily to scale. Not all components shown.
9. When the Set Screws are correctly installed, put the large washer and hex head bolt into place on
the end of the Shaft (the Hex Head Bolt Hole) and tighten the hex head bolt.
10. Switching to the top of the Hood Mount Arm , remove the two hex bolts and the split lock
washers.
They come from the factory in place at the top of the Hood Mount Arm.
11.
Switching to the Hood
, put the Rod on one corner of the Hood into position next to the top of
the Hood Mount Arm.
The Handle in the Hood should be at the front of the Balancer.
12. Replace the two hex bolts and split lock washers you just removed; tighten them securely.
13. Test the Hood to make sure it moves back and forth smoothly.