Ranger DST30P, Инструкция по установке и эксплуатации

Страница: 19 / 60

DST30P Wheel Balancer
19
P/N 5900163 — Rev. C1 — March 2020
Anchoring the Balancer
The Balancer has three holes for Anchor Bolts, which hold the Balancer in place while you use it.
Important : You are
required
to bolt your Balancer into place, as movement during a Wheel
Balance can cause bad readings.
To anchor the Balancer :
1. Move the Balancer to the desired location.
Remember that you need to allow some space around the Balancer. Refer to
Finding a
Location for additional information.
2. Using the holes in the base as guides, drill the holes for the 3/8 in by 4 in Anchor Bolts.
Go in straight; do not let the drill wobble. Use a carbide bit (conforming to ANSI B212.15-1994).
The diameter of the drill bit must be the same as the diameter of the Anchor Bolt. So if you are
using a 3/8 in diameter Anchor Bolt, for example, use a 3/8 in diameter drill bit.
3. Vacuum each hole clean.
BendPak Ranger recommends using a vacuum to get the hole very clean.
Do
not
ream the hole. Do
not
make the hole any wider than the drill bit made it.
4. Make sure the Washer and Nut are in place, then insert the Anchor Bolt into the hole.
The Expansion Sleeve of the Anchor Bolt may prevent the Anchor Bolt from passing through the
hole in the Base Plate; this is normal. Use a hammer or mallet to get the Expansion Sleeve through
the Base Plate and into the hole.