Rangemaster Toledo 90 Gas, Руководство пользователя

Страница: 14 / 32

14
some window doors only
Carefully lift off the outer door panel. The inside
face of the glass panels can now be cleaned
- take care not to disturb or wet the door
insulation. Please note that the door is triple
glazed but the inner two panels are fi xed and
should not be separated. After cleaning carefully
refi t the outer door panel and replace the side
fi xing screws.
The Main Oven
The Main oven has panels which have been
coated with a special enamel that partly cleans
itself. This does not stop all marks on the lining,
but helps to reduce the amount of manual
cleaning needed.
The Cook & Clean panels work better above
200°C. If you do most of your cooking below
this temperature, occasionally remove the
panels and wipe with a lint free cloth and
hot soapy water. The panels should then be
dried and replaced and the oven heated at
200°C for about one hour. This will ensure
the Cook & Clean panels are working
effectively.
Don’t use steel wool (Brillo) or any other
materials that will scratch the surface. Don’t use
oven cleaning pads.
Removing the Main Oven Linings
Some of the lining panels can be removed for
cleaning and for cleaning behind. Remove the
shelves fi rst.
On some models
the Main oven has a
removable oven roof
- if fi tted slide the
roof liner forward and
remove.
The side panels of the main oven can be
removed.
Cleaning for burned-on spills
Be sure that the heat indicator lights are off
and the hob is cool. Remove excess burned-on
substance with a single-edged razor scraper.
Hold the scraper at approximately a 30° angle to
the surface and scrape off the burned-on matter
as you would scrape paint off of a window.
IMPORTANT: Take care when using a sharp
scraper.
When you have removed as much as possible
with the scraper clean using the daily care
procedure as described above.
To remove metal rub-off
Sliding pans on the hob - especially aluminium
or copper pans can leave marks on the surface.
These marks often appear like scratches, but
can be easily removed using the procedure
described above for cleaning spills. If the rub-off
marks are especially stubborn, use the cleaning
cream together with the razor scraper, using the
technique described above.
Control Panel and Doors
The control panel and control knobs should
only be cleaned with a soft cloth wrung out
in clean hot soapy water -
but take care that
no surplus water seeps into the appliance.
Wipe with a clean dampened cloth then polish
with a dry cloth. The oven doors should only be
cleaned with a soft cloth wrung out in clean hot
soapy water.
Cookers with window doors
On some models the oven door front panel can
be taken off so that the glass panels can be
cleaned. If the top edge of the oven door of your
cooker has a line of holes and there are screws
in the side edges then it can be taken apart for
cleaning.
Move the cooker forward to gain access to the
sides (see the ‘Moving the cooker’ section of
these instructions).
Open the oven door slightly and remove the
front panel fi xing screws from the door sides
(two each side).