WARNING – SERVICING TO BE CARRIED OUT ONLY BY AN AUTHORISED PERSON
Disconnect from electricity and gas before servicing. Check appliance is safe when you have finished.
29
ArtNo.281-0116 - Oven Thermostat Phial
�����
Fig.9-5
11. To Remove a Hotplate Burner Thermocouple
Disconnect the cooker from the electricity supply.
Remove the hotplate
(see 2)
.
Identify the thermocouple to be removed. Pull off the
connection at the tap end and lift the thermocouple away at
the burner end.
Fit the new thermocouple in the reverse order.
Replace the hotplate. Check the thermocouple for correct
operation at full rate and turndown.
12. To Change the Ignition Spark Generator
Disconnect the cooker from the electricity supply.
Remove the hotplate
(see 2)
.
Disconnect all the leads from the generator, taking note of
their positions. Unclip the generator from the cooker.
Fit the new generator and reconnect the leads. Check for
correct ignition.
13. To Change an Oven Light Bulb
Disconnect the cooker from the electricity supply.
Make sure the oven is cool. Open the oven door and remove
the oven racks.
Unscrew the bulb cover by turning counter clockwise. It may
be very stiff
(Fig.9-6)
.
Taking care to protect your fingers in case the bulb should
shatter, unscrew the old bulb.
Screw in the new bulb and then screw the bulb cover back on.
Turn on the circuit breaker and check that the bulb now lights.
Replacement bulb must be 15 W 240 V lamp, FOR OVENS, heat
resistant to 300 °C.
14. To Change the Oven Multi-function Switch
Move the cooker away from the wall to allow access to the
rear.
Remove the pan supports and burner heads. Remove the
control panel
(see 1)
and hotplate
(see 2)
.
Remove the fixing screws from the front of the oven multi-
function switch. Disconnect the leads and remove the switch.
Fit the new switch.
15. To Replace a Door Inner Panel
Remove the door
(see page 23, ‘Removing the Oven Door’)
.
Carefully place the door, outer side up, on a clean level surface.
Remove the 2 hexagon headed screws from the inside face
and the 3 hexagon headed screws on the bottom edge
(Fig.9-7)
.
Remove the corner brackets, and then lift off the inner door
panel. Take care not to damage the inner glass.
Reassemble in the reverse order.
16. To Replace an Over Door Hinge
Remove the door
(see page 23, ‘Removing the Oven Door’)
.
Carefully place the door, inner side up, on a clean level surface.
Remove the 2 hexagon headed screws from the inside face
and the 3 hexagon headed screws on the bottom edge
(Fig.9-7)
.
�����������������������������������������������������������������
Fig.9-7
ArtNo.324-0007 Unscrewing the bulb cover
Fig.9-6
