22
ArtNo.010-0004 Moving the cooker
ArtNo.092-0002 - 90 single cavity - Stability bracket fitting
A
100 mm
C
D
550 mm
550 mm
B
B
Removing the Oven Door
To remove the oven door, open the door fully. Swivel the
locking ‘U’ clips forward to the locking position
(Fig.7-5)
. Grip
the sides of the door, lift upwards and then slide the door
forwards
(Fig.7-6)
.
When you have removed the oven door continue as follows:
First fit the levelling tool on the hexagonal adjusting nut
(Fig.7-7)
.
Make 10 complete (360°) turns clockwise
(Fig.7-7)
. This
means turning and removing the levelling tool 20 times.
Completing the Move
Unfold the rear edge of the pack base tray. Grip the fascia
panel and lift the front of the cooker slightly
(Fig.7-8)
.
Carefully push the cooker backwards off the pack base.
Remove the pack base. Position the cooker close to its final
position, leaving just enough space to get behind it.
DO NOT use the control knobs to manoeuvre the cooker.
Levelling
You are recommended to use a spirit level on a shelf in one of
the ovens to check for level.
Place the cooker in its intended position, taking care not to
twist it within the gap between the kitchen units as damage
may occur to the cooker or the units.
The front feet and rear rollers can be adjusted to level the
cooker. To adjust the height of the rear of the cooker use the
levelling tool supplied to turn the adjusting nuts at the front
bottom corners of the cooker. To set the front feet turn the
bases to raise or lower.
Leave the levelling tool in the storage drawer, so that the
customer can use it if they wish to move the cooker.
Fitting a Stability Bracket
A stability bracket or chain (not supplied by with the cooker)
should be fitted when the cooker is connected to a flexible
gas supply.
When fitting a stability bracket read these instructions
together with the leaflet supplied with the bracket.
1.
Place the cooker in its intended position and level the
cooker.
2.
Draw a pencil line 70 mm from the front edge of the
levelling feet
(Fig.7-9)
.
3.
Mark the centreline for the bracket by measuring
550 mm from the left-hand side of the cooker.
4.
Lower the front roller and move the cooker forward.
5.
Measure back from the pencil line 550 mm to locate the
front edge of the bracket
(Fig.7-9)
. Fix the bracket to
the floor.
6.
Measure the height from floor level to engagement
edge in back of cooker. Add 3 mm to this dimension and
assemble the stability bracket to this height (i.e. from
ArtNo.010-0010 Lowering the rear rollers (90)
x10
�������������������������������������������
Fig.7-6
Fig.7-7
Fig.7-8
Fig.7-9
A - Wall face, B - Rear rollers, C - Front levelling feet,
D - Pencil datum line
ArtNo.062-0001 - 90 Prof+ FX - Removing the door
Fig.7-5
