Rangemaster HAP5200 532 Series, Руководство пользователя

Страница: 25 / 32

INSTALLATION
Check the appliance is electrically safe and gas sound when you have finished.
23
Electrical Connection
The cooker must be installed by a qualified electrician, in
accordance with all relevant British Standards/Codes of
Practice (in particular BS 7671), or with the relevant national
and local regulations.
Current Operated Earth Leakage Breakers
The combined use of your cooker and other domestic
appliances may cause nuisance tripping, so we
recommend that the cooker is protected on an individual
RCD (Residual Current Device) or RCBO (Residual Current
Breaker with Overload).
IF IN DOUBT, PLEASE CONSULT A SUITABLY QUALIFIED
ELECTRICIAN.
Note: The cooker must be connected to the correct electrical
supply as stated on the voltage label on the cooker, through
a suitable cooker control unit incorporating a double pole
switch, having a contact separation of at least 3 mm in all
poles.
The cooker MUST nOT be connected to an ordinary domestic
power point.
Access to the mains terminal is gained by removing the
electrical terminal cover box on the back panel. Connect
the mains cable to the correct terminals for your electrical
supply type (Fig.7-12 and Fig.7-13). Check that the links are
correctly fitted and that the terminal screws are tight. Secure
the mains cable using the cable clamp.
Hotplate Check
Check each burner in turn (refer to the ‘Hotplate Burners’
section at the front of the instructions).
Grill Check
Turn on the grill control and check that the grill heats up.
Oven Check
Set the clock as described earlier in the instructions, and then
turn on the ovens. Check that the oven fans start to turn and
that the ovens start to heat up.
Note: The oven light bulb is not included in the guarantee.
Turn off the oven.
Fitting the Plinth
Fit the inner plinth to the bottom front of the cooker using
the 5 screws provided (Fig.7-14).
Fit the outer plinth (2 screws 1 each end) to the inner plinth
(Fig.7-15). Adjust the height of the outer plinth by sliding it
up or down via the slotted hole.
Customer Care
Installer: Please complete your details in this Guide, inform
the user how to operate the cooker and hand oven the
instructions.
Thank you.
ArtNo.130-0010 Electrical connections single-phase
L
N
230 V ac 50 Hz
10mm² max
Fig.7-12
ArtNo.350-0010 - Fitting the plinth 1 (Kitchener)
Fig.7-14
ArtNo.130-0010 Electrical connections 3-phase
L1
N
L3
L2
3N ac
230/400 V 50 Hz
6 mm² max
10 mm² max
Fig.7-13
ArtNo.350-0011 - Fitting the plinth 2 (Kitchener)
Outer plinth
Outer plinth fixing screw
Inner plinth
Fig.7-15