Rangemaster GLX490 RM, Инструкция по эксплуатации

Страница: 6 / 16

EN
6
6
INSTALLATION
Hood body mounting
• Firstly, it is necessary to adjust the two Vr- screws of
the 11a- brackets, at minimun ( B ).
• Hang the hood body on the two brackets 11a .
• Connect the hood to the mains supply by means of a
bipolar switch with at least 3 mm contact gap.
• Press the “ A ”-key for one second (see Part USE) to
open the upper panel.
• Remove the metal filters.
• In order to align the hood it is necessary to adjust the
Vr- screws from inside the hood.
• Fasten the safety screw 11 .
• Fit again the metal filters into their seats and close the
upper panel by pressing “ L ”-key for one second (see
Part USE).
• Disconnect the hood from the mains supply.
Attention: the upper panel stops if any barrier occurs in its
way during the panel opening or closing. To open the panel
it is enough to remove the barrier and press the key once
again.
( B )
L
A
11a
Vr
11
Connections
DUCTED VERSION AIR EXHAUST SYSTEM
When installing the ducted version, connect the hood to
the chimney using either a flexible or rigid pipe ø 150
or 125 mm, the choice of which is left to the installer.
• To install a ø 125 mm air exhaust connection, insert
the reducer flange 9 on the hood body air outlet and
the adapting ring ø120-125 10 on the reducer flange.
• Fix the pipe in position using sufficient pipe clamps
(not supplied).
• Remove any activated charcoal filters.
9
ø 125
10
ø 150