Manual-3
Rear Panel Description
1
MASTER IN
are balanced Tip-Ring-Sleeve (TRS) ¼" Master Inputs. These Inputs feed all six MONO OUTs when all MONO
INs are not used. Connecting to individual MONO INs disconnects that channel from these Inputs (refer to the Block Diagram).
For unbalanced operation use a standard mono ¼" plug; for balanced operation use a TRS (stereo) ¼" plug wired as follows:
TIP is (connect to Pin 2 on a 3-pin connector).
RING is signal – (pin 3 in a 3-pin connector).
SLEEVE is chassis ground.
2
MONO INPUTS
are TRS ¼" jacks which accept either balanced or unbalanced mono signals. These are switching jacks which
automatically bypass the MASTER IN jacks whenever a plug is inserted (see the Block Diagram). Same wiring conventions as in
1
above.
3
MONO OUTPUTS
are ¼" TRS jacks that deliver either an unbalanced output (use TS plugs), or a balanced output (use TRS
plugs). Follow wiring conventions as in
1
above.
4
EXPAND OUTS
are ¼" TRS jacks connected in parallel with the MASTER IN jacks, allowing two or more SM26Ss to be
daisychained for multiple splitting. Simply connect the EXPAND OUT to the MASTER IN of another SM26S; there is no limit
to the number of expansions possible with the SM26S.
NOTE: These Expand Outputs are
not
buffered from the Master Inputs. Therefore it is not possible to mix both balanced and
unbalanced lines in the same channel between several units: once the ring and sleeve are shorted anywhere in the chain (by using a
mono plug) the entire line becomes unbalanced.
5
MIX OUTPUTS
are balanced TRS ¼" outputs controlled by the MASTER OUTPUT LEVEL control. They are fed either by
the MASTER IN or by any of the six MONO INPUTS, or a combination of both (see
The Swiss Army Mixer
RaneNote). Follow
wiring conventions as in
1
above.
6
Universal Voltage Input:
via a miniature IEC 60320 C6 appliance inlet. This mates with an IEC 60320 C5 line cord (USA
domestic). Do
not
lift the ground connection!
SM26S
All Inputs and Outputs are Balanced: Tip = positive (+), Ring = Negative (–), Sleeve = Chassis Ground.
All audio jacks are Class 2 wiring.
LEFT
RIGHT
LEFT
RIGHT
MONO OUTPUTS
MONO INPUTS
6
5
4
3
2
1
6
5
4
3
2
1
MIX OUTPUT
EXPAND OUT
MASTER IN
100-240 V
50/60 Hz 7 WATTS
RANE CORPORATION
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) this device may not cause harmful interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation. CAN ICES-3 (B)/NMB-3(B)
COMMERCIAL AUDIO
EQUIPMENT 24TJ
R
5
1
2
3
4
6
Содержание SM 26S
Страница 4: ......
