Remote-Control Commands
R&S
®
SMCVB-K163
58
User Manual 1179.0997.02 ─ 02
[:SOURce<hw>]:BB:DVBT:INPut:FORMat
.......................................................................... 58
[:SOURce<hw>]:BB:DVBT:INPut:TSCHannel[:HIGH]
........................................................... 59
[:SOURce<hw>]:BB:DVBT:STUFfing:LOW
..........................................................................59
[:SOURce<hw>]:BB:DVBT:STUFfing[:HIGH]
....................................................................... 59
[:SOURce<hw>]:BB:DVBT:SOURce:LOW
<SourceLP>
[:SOURce<hw>]:BB:DVBT:SOURce[:HIGH]
<SignalSourceHp>
Sets the modulation source for the input signal.
Parameters:
<SignalSourceHp>
TSPlayer | EXTernal | TESTsignal
*RST:
EXTernal
Example:
See
Example "Configuring general input signal properties"
Manual operation:
See
[:SOURce<hw>]:BB:DVBT:INPut:LOW
<InputLP>
[:SOURce<hw>]:BB:DVBT:INPut[:HIGH]
<Input>
Sets the external input interface.
Parameters:
<Input>
IP | TS
TS
Input for serial transport stream data. The signal is input at the
"User 1/2" connectors.
IP
Supported for high priority path (HP) only, i.e. setting requires
non-hierarchical coding.
Input for IP transport stream data. The signal is input at the "IP
Data" connector.
*RST:
TS
Example:
See
Example "Configuring general input signal properties"
Manual operation:
See
[:SOURce<hw>]:BB:DVBT:INPut:FORMat:LOW
<InputFormatLP>
[:SOURce<hw>]:BB:DVBT:INPut:FORMat
<InputFormat>
Sets the format of the input signal.
Parameters:
<InputFormat>
ASI | SMPTE
*RST:
ASI
Example:
See
Example "Configuring general input signal properties"
Input Commands