DVB-T Configuration and Settings
R&S
®
SMCVB-K163
18
User Manual 1179.0997.02 ─ 02
Input
Requires "Source > External".
Sets the external input interface.
"TS IN"
Input for serial transport stream data. The signal is input at the "User
1" connector.
"IP"
Requires "Hierarchy > Non Hierarchical", i.e. IP input requires non-
hierarchical coding.
Input for IP-based transport stream data (TSoverIP). The signal is
input at the "IP Data" connector.
Remote command:
Non-hierarchical coding
[:SOURce<hw>]:BB:DVBT:INPut[:HIGH]
Hierarchical coding
[:SOURce<hw>]:BB:DVBT:INPut[:HIGH]
[:SOURce<hw>]:BB:DVBT:INPut:LOW
Input Format
Requires "Input > TS IN".
Sets the format of the input signal.
"ASI"
format
"SMPTE 310"
Remote command:
Non-hierarchical coding
[:SOURce<hw>]:BB:DVBT:INPut:FORMat
Hierarchical coding
[:SOURce<hw>]:BB:DVBT:INPut:FORMat
[:SOURce<hw>]:BB:DVBT:INPut:FORMat:LOW
IP TS Channel
Requires "Input > IP".
Selects the IP-based transport stream (TS) channel. You can select 1 out of 4 IP TS
channels as input at the "IP Data" interface.
To configure a particular channel, see
Chapter 4.2.4, "IP Channnel x Settings"
Remote command:
Non-hierarchical coding only
[:SOURce<hw>]:BB:DVBT:INPut:TSCHannel[:HIGH]
Stuffing
Requires "Source > External/TS Player".
Activates stuffing.
"On"
The installed input interface provides the transport stream data rate
required for the current modulation parameters (regardless of the
input data rate of the external transport stream).
Input Signal Settings