R&S NRX-B4, Руководство пользователя

Страница: 57 / 450

Configuration for All Measurement Types
R&S
®
NRX
57 User Manual 1178.5566.02 ─ 05
Specific Trigger ............................................................................................................. 59
└ Jitter Suppression ........................................................................................... 59
└ Trigger Master State ....................................................................................... 59
└ Trigger Master Port ......................................................................................... 59
└ Trigger Synchronize State .............................................................................. 59
└ Trigger Synchronize Port ................................................................................ 59
└ Trigger 2 Input Impedance ..............................................................................60
Trigger Mode
Controls the trigger execution depending on the settings under "Trigger Source"
on page 57.
"Normal" Continuous triggering with regular trigger events.
"Freerun" Enables a continuous measurement. The power sensor executes one
measurement cycle after the other.
"Single" Available for trace, statistics measurements.
Disables continuous triggering so that only one trigger event at a time
is executed. To enable triggering again, press [1Trig].
"Auto" Available for trace, statistics measurements.
Automatically starts a measurement if no trigger event has occurred
after 300
ms.
Remote command:
TRIGger<undef>:ALL:MODE
on page 212
TRIGger<Measurement>:MODE
on page 212
Trigger Source
"Primary Sensor Trigger Source", "Secondary Sensor Trigger Source"
Sets the source for the trigger event. See Chapter 7.3.2, "Trigger Sources" ,
on page 54.
Remote command:
TRIGger<undef>:ALL:SOURce
on page 214
TRIGger<Measurement>[:CHANnel<Channel>]:SOURce
on page 214
Trigger Level
"Primary Sensor Trigger Level", "Secondary Sensor Trigger Level"
Sets the trigger threshold for internal triggering derived from the test signal.
The trigger level is displayed as dotted red line. The trigger time is displayed as small
rhomb on the trigger level line.
Remote command:
TRIGger<undef>:ALL:LEVel
on page 211
TRIGger<Measurement>[:CHANnel<Channel>]:LEVel
on page 211
Trigger Advanced
"Primary Sensor Trigger Advanced", "Secondary Sensor Trigger Advanced"
Groups further trigger settings.
Triggering