R&S NRP Series, Руководство пользователя

Страница: 45 / 161

Browser-based user interface
R&S
®
NRPxxA(N)
45 User Manual 1177.6017.02 ─ 08
● Sensor settings ....................................................................................................... 45
● Averaging settings ...................................................................................................46
● Trigger settings ....................................................................................................... 47
● System settings .......................................................................................................49
6.5.1 Sensor settings
Describes the parameters for optimizing the measurement results for specific measure-
ment requirements.
Further information:
●
Chapter 9.4.2, "Selecting a measurement path" , on page 64
●
Chapter 9.8.3, "Configuring corrections" , on page 90
●
Chapter 9.10, "Calibrating, zeroing" , on page 106
●
Chapter 9.11, "Testing" , on page 108
Access: main dialog of the web user interface > navigation pane > "Sensor"
Range ............................................................................................................................45
Γ Correction ...................................................................................................................45
└ <State> ........................................................................................................... 45
└ Magnitude ....................................................................................................... 46
└ Phase ..............................................................................................................46
Zero Calibration .............................................................................................................46
Sensor Information ........................................................................................................46
Range
Selects which path of the sensor is used for the measurement.
Remote command:
[SENSe<Sensor>:]RANGe:AUTO
on page 65
[SENSe<Sensor>:]RANGe
on page 64
Γ Correction
Groups the parameters for the complex reflection coefficient. See also Chapter 9.8.3.4,
"S-gamma corrections" , on page 92.
<State> ← Γ Correction
Enables or disables the use of the complex reflection coefficient of the signal source,
Γ
source
.
Remote command:
[SENSe<Sensor>:]SGAMma:CORRection:STATe
Settings