R&S FSW Series, Руководство пользователя

Страница: 357 / 1450

Common Measurement Settings
R&S
®
FSW
357 User Manual 1173.9411.02 ─ 43
1. "Select Measurement"
See Chapter 7, "Measurements and Results" , on page 131
2. Input
See Chapter 8.2.2, "Input Source Settings" , on page 366
3. Amplitude
See Chapter 8.4, "Amplitude and Vertical Axis Configuration" , on page 448
4. Frequency
See Chapter 8.3, "Frequency and Span Configuration" , on page 441
5. (Optionally:) Trigger/Gate
See Chapter 8.6, "Trigger and Gate Configuration" , on page 476
6. Bandwidth
See Chapter 8.5.2, "Bandwidth, Filter and Sweep Settings" , on page 465
(For SEM measurements: SEM Setup, see Chapter 7.6.5, "SEM Configuration" ,
on page 250)
(For Spurious measurements: Spurious Setup, see
Chapter 7.7.4, "Spurious Emis-
sions Measurement Configuration" , on page 284)
7. (Optionally:) Outputs
See Chapter 8.2.6, "Output Settings" , on page 436
8. Analysis
See Chapter 9, "Common Analysis and Display Functions" , on page 501
9. Display
See Chapter 9.1, "Result Display Configuration" , on page 501
To configure settings
► Select any button to open the corresponding dialog box.
Select a setting in the channel bar (at the top of the channel tab) to change a spe-
cific setting.
Preset Channel
Select the "Preset Channel" button in the lower left-hand corner of the "Overview" to
restore all measurement settings
in the current channel to their default values.
Do not confuse the "Preset Channel" button with the [Preset] key , which restores the
entire instrument to its default values and thus closes all channels on the R&S FSW
(except for the default channel)!
Remote command:
SYSTem:PRESet:CHANnel[:EXEC]
on page 1242
Configuration Overview