R&S FSV-K8, Руководство по эксплуатации

Страница: 56 / 135

Instrument Functions for Bluetooth Measurements (K8)
R&S
®
FSV-K8
56 Operating Manual 1176.7610.02 ─ 02
Center
Opens an edit dialog box to change the center frequency.
If the frequency channel was set via the "Channel" softkey (see "Channel"
on page 36), you can change the center frequency, but the relation to the frequency
channel will be lost, which means that the value range for the center frequency is not
limited to frequencies within valid frequency channels.
The fixed relation between center frequency and Bluetooth frequency channels is
restored when you press the "Channel" softkey or select another measurement. The
center frequency is rounded to the nearest frequency channel.
Remote command:
[SENSe:
​
]FREQuency:
​
CENTer
​
on page 115
CF–Stepsize
Opens a submenu to set the step size of the center frequency.
0.1*Chan Spacing ← CF–Stepsize
Sets the step size of the center frequency to 1/10 of the channel spacing.
= Chan Spacing ← CF–Stepsize
Sets the step size of the center frequency to the size of the channel spacing.
3.8 Softkeys of the Sweep Menu (Bluetooth mode)
The following table shows all softkeys available in the sweep menu in Bluetooth mode
(SWEEP key). In the Bluetooth mode, the sweep menu is used for direct entry into the
measurement menu of the currently selected measurement. It is possible that your
instrument configuration does not provide all softkeys. If a softkey is only available with
a special option, model or (measurement) mode, this information is delivered in the
corresponding softkey description.
Continuous Sweep
Sets the continuous sweep mode: the sweep takes place continuously according to the
trigger settings. This is the default setting.
The trace averaging is determined by the sweep count value (see the "Sweep Count"
softkey,
"Sweep Count" on page 57).
Remote command:
INIT:CONT ON
, see
INITiate<n>:
​
CONTinuous
​
on page 109
Single Sweep
Sets the single sweep mode: after triggering, starts the number of sweeps that are
defined by using the
Sweep Count softkey. The measurement stops after the defined
number of sweeps has been performed.
Remote command:
INIT:CONT OFF
, see
INITiate<n>:
​
CONTinuous
​
on page 109
Softkeys of the Sweep Menu (Bluetooth mode)