LTE Multi Evaluation Measurement
R&S
®
CMW-KM5xx/-KS5xx
654
User Manual 1173.9628.02 ─ 16
<Band>
*RST <OnPowerUpper>
*RST <OnPowerLower>
100
1.9 dBm
-13.1 dBm
150
3.6 dBm
-11.4 dBm
200
4.9 dBm
-10.1 dBm
3.5.3.15
Detected Signal Configuration
The following commands return the detected allocation, modulation scheme and chan-
nel type and the view filter throughput.
FETCh:LTE:MEAS<i>:MEValuation:MODulation:DMODulation?
......................................... 654
FETCh:LTE:MEAS<i>:MEValuation:MODulation:DCHType?
.............................................. 654
FETCh:LTE:MEAS<i>:MEValuation:ACLR:DCHType?
.......................................................654
FETCh:LTE:MEAS<i>:MEValuation:SEMask:DCHType?
................................................... 654
FETCh:LTE:MEAS<i>:MEValuation:MODulation:DALLocation?
.......................................... 655
FETCh:LTE:MEAS<i>:MEValuation:ACLR:DALLocation?
...................................................655
FETCh:LTE:MEAS<i>:MEValuation:SEMask:DALLocation?
............................................... 655
FETCh:LTE:MEAS<i>:MEValuation:VFTHroughput?
......................................................... 655
FETCh:LTE:MEAS<i>:MEValuation:MODulation:DMODulation?
Returns the detected modulation scheme in the measured slot. If channel type PUCCH
is detected, QPSK is returned as modulation type because the QPSK limits are applied
in that case.
Return values:
<Reliability>
<Modulation>
QPSK | Q16 | Q64
QPSK, 16-QAM, 64-QAM
Example:
See
Performing Single-Shot Measurements
Usage:
Query only
Firmware/Software:
V2.0.10
FETCh:LTE:MEAS<i>:MEValuation:MODulation:DCHType?
FETCh:LTE:MEAS<i>:MEValuation:ACLR:DCHType?
FETCh:LTE:MEAS<i>:MEValuation:SEMask:DCHType?
Returns the detected channel type for the measured slot.
If the same slot is measured by the individual measurements, all commands yield the
same result. If different statistic counts are defined for the modulation, ACLR and spec-
trum emission mask measurements, different slots may be measured and different
results may be returned by the individual commands.
Return values:
<Reliability>
Command Reference
135-1095-0799