Page
9
of
24
LP0293
R&G
Unit 1, Shelley’s Lane, East Worldham, Al
ton, Hampshire, GU34 3AQ
Tel: +44 (0)1420 89007 Fax: +44 (0)1420 87301
Email:
FITTING INSTRUCTIONS
•
Remove the panniers and luggage rack (the method will vary depending on the manufacturer).
•
Remove the passenger seat using the key as arrowed in
picture 1
.
•
Remove the two bolts arrowed in
picture 2
and remove the rider
’
s seat.
•
Remove the five bolts arrowed in
picture 3
.
•
Remove the four luggage spacers as shown in
pictures 4
and
5
.
•
Remove the six bolts arrowed in
pictures 6
and
7
.
•
Remove the three bolts arrowed in
picture 8
and remove the infill panel.
•
Remove the three bolts arrowed in
picture 9
and remove the infill panel.
•
Remove the two push rivets arrowed in
pictures
10
and
11
.
•
Gently and carefully spread the seat cowling and push in the direction of arrows as shown in
picture 12
to remove the seat cowl.
•
Remove the four plug sockets arrowed in
picture 13
.
•
Remove the two nuts arrowed in
picture 14
.
•
Remove the four bolts arrowed in
picture 15
and remove the original rear light/licence plate
bracket.
•
Remove the three bolts arrowed in
pictures 16
and
17
, then remove the original metal
bracket from the assembly.
•
Remove the four bolts arrowed in
pictures 18
and
19
, then remove the wiring cover from the
assembly.
•
Remove the four bolts arrowed in
picture 20
, then remove the cover panel.
•
Remove the rear light and bracket (you will need to remove several cable ties to free the
wiring).
If reusing the original indicators
•
Remove the spreader plate as shown in
picture 21
and carefully squeeze the indicator stalk
and remove the indicator from the bracket, then repeat for the remaining indicator (please note
which side they were removed from.
•
Place the thin indicator adaptor (
item 10
) onto both indicator stalks as shown in
pictures 22
and
23
.
•
Gently squeeze the indicator stalk and fit to the new licence plate bracket (
item 1
) and secure
as original with the spreader plate as shown in
picture
24
.
•
Fit the remaining indicator as above.
If using R&G mini indicators
•
If using mini indicators, fit the indicators of choice to the new licence plate bracket (
item 1
)
(R&G mini indicator product code RG371 for LED type or RG372 for Aero Style led type) as
shown in
pictures 25
and
26
using the four mini indicator adaptors (
items 11
).
•
Secure the mini indictors in position using the M8 nut provided as shown in
picture 26
.
•
Feed the indicator wiring through one of the nut/wire covers (
item 12
) as shown in
pictures
27
and 28
(it helps if a small amount of liquid detergent is used) and position the nut cover
over the nut (repeat the above for the opposite indicator).
•
Fit one length of heat-shrink (
item 16
) over each the of indicator wires so the heat-shrink fits
over the stem of the nut/wire cover and gently heat until the heat-shrink contracts to the wiring
and nut/wire cover as shown in
pictures 28
.
