Page
10
of
24
LP0293
R&G
Unit 1, Shelley’s Lane, East Worldham, Al
ton, Hampshire, GU34 3AQ
Tel: +44 (0)1420 89007 Fax: +44 (0)1420 87301
Email:
To continue
•
Feed the wires of the new R&G licence plate illuminator (
item 14
) through the central hole in
the new licence plate bracket (
item 1
) as shown in
pictures 29
and
30
.
•
Secure using the washers and nuts supplied as shown in
picture 30
.
•
Fit one length of heat-shrink (
item 16
) to the wires and heat gently to shrink to fit.
•
Fit the light shroud and use a small amount of adhesive to hold it in position as shown in
picture 31
.
•
Place the licence plate support bracket (
item 6
) under the licence plate bracket (
item 1
) as
shown below and secure in position using the bolt, nut and washer (i
tems 7, 8 and 9
).
•
Please ensure the wiring and wiring covers are neat and tidy using the supplied clips and cable
ties (
items 17
and
19
) as shown in
picture 32
.
•
Offer the entire assembly up to the motorcycle and secure in position using the four M6 bolts
with washers (
items 2
and
3
).
•
Refit the rear light and bracket as original using the two shorter M5 bolts and washers (
items 4
and
5
) through the rear two holes in the new licence plate bracket as shown below, refit the
two original nuts.
