Page
7
of
19
LP0256
R&G
Unit 1, Shelley’s Lane, East Worldham, Alton, Hampshire, GU34 3AQ
Tel: +44 (0)1420 89007 Fax: +44 (0)1420 87301
www.rg-racing.com
Email:
Picture 23
Picture 24
Picture 25
Picture 26
FITTING INSTRUCTIONS
Remove the seat.
Undo the T40 Torx bolt which secures the RH exhaust to the exhaust mount (shown in Picture 1), and carefully
pull the exhaust silencer out of the exhaust pipe.
Repeat the previous step on the LH exhaust.
Remove the two bolts securing the brake light assembly (shown in Picture 2), and carefully pull the brake light
assembly rearwards to remove it from the mounting plate.
The brake light mounting plate can now be removed, by undoing the three bolts shown in Picture 3.
Undo the two bolts securing the exhaust mount (Picture 4) and remove the mount.
Remove the two lower bolts securing the upper rear body panel (shown in Picture 5), ensuring that the spacers
are put to one side ready for re-installation later.
Remove the two upper bolts (shown in Picture 6) securing the upper rear body panel, and carefully remove the
panel (shown in Picture 7).
Remove the four bolts shown in Picture 8 and be sure to support the plastic undertray to prevent damaging the
indicator wires.
