RAMSET ROCKET TOOL, Инструкция по безопасности и эксплуатации оператора

Страница: 10 / 18

4. Hold the tool perpendicular (90°) to
the work surface with both hands and
press firmly to fully depress the tool.
Maintain firm downward pressure on
the tool with both hands and pull the
trigger to drive the fastener.
DO NOT
DEPRESS THE TOOL AGAINST
ANYTHING OTHER THAN THE
INTENDED WORK SURFACE.
Holding
the tool firmly in place will produce
more consistent fastening quality and
minimize tool wear or damage.
5. After making the fastening, let up
on the tool pressure and note that
the barrel assembly returns to the
full open position. This automatically
resets the piston for the next fastening.
Always keep fingers and other body
parts away from the muzzle end of
the tool.
6. Insert another fastener in the muzzle
end of the tool as before and the tool
is ready for the next fastening. Keep
your finger off of the trigger until the
tool is in position to drive the fastener.
7. To remove a used or partially used
strip load from the tool, pull the strip
out from the top of the tool.
NEVER
try to remove a jammed or stuck
load strip. Should a “jammed” load
strip occur, call your local Authorized
Ramset Distributor for technical
assistance.
POWER LEVEL ADJUSTMENT
The power of the tool may be adjusted
for varying materials by turning the power
adjust wheel.
TOOL OPERATING INSTRUCTIONS
TOOL OPERATING INSTRUCTIONS
10
90°
HOLD THE TOOL FIRMLY AND
PERPENDICULAR TO THE WORK SURFACE
LET UP ON TOOL PRESSURE.
NOTE THE BARREL HAS RETURNED
TO THE OPEN POSITION
INSERT THE NEXT FASTENER
REMOVE THE LOAD STRIP
+ INCREASE
- DECREASE
POWER LEVEL ADJUSTMENT