PUSHBUTTON CONTROLS
Three pushbuttons are located under the dip switches lor operation of the gate (see Figure 11 ). The
opening.
stop
and
closing
buttons can be utilized to set limit switches and verify proper system operation when
installing or servicing an operator.
Opening
Pressing this button will cause the gate to open.
L.E.D.'s light up when Opening,
Closing or Stopped
Stop
Pressing this button will cause the gate to
stop moving.
Closing
Pressing this button will cause the gate to close.
Reset E.R.o.
Board
Push all three pushbuttons for approximately
5 seconds. All three L.E.D.'s should blink.
liH
1
HJfJ
MASTER/ SLAVE INSTALLATION
Set Dip Switch (CB)" Slave Mode" to ON for
slave operator.
(RH) Right Hand operation requires Dip Switch
(C7) "Left/Right" to be ON.
Use 3-stranded, shielded wires
(not •upplled) from Master to Slave.
Route low-voltage wires for Master/Slave
In a conduit ttRarate from power.
l#l
·
ltlii■I
11
www.RamsetStore.com | (800) 878-7829 | [email protected]
