RAMSET RA27, Инструкция по безопасности и эксплуатации оператора

Страница: 7 / 36

Your Ramset RA27 Tool uses only the Ramset fasteners and loads shown below or
listed for the tool in the Product Catalog.
FASTENERS
FASTENERS / LOADS
FASTENERS / LOADS
7
Never use any other types of fasteners or strip loads in the Ramset RA27 Tool. Use of other
types of fasteners or loads may cause unintentional load discharge, damage the tool, cause
poor fastening performance, or create a risk of serious injury to the operator or bystanders.
DANGER
LOADS
Ramset RS27 strip loads are specially made for use in the Ramset RA27 Tool.
The power level of the load is indicated by
the number marked on each box, the color
of the box, and the color on the tip of each
load. As the number increases, the power
level also increases.
Always perform the center punch test
described on page 3 to test the base material.
Always make a test fastening using the
lowest power level first. If more power is
required to set the fastener, use the next
higher power level until the powder level
necessary to drive the fastener is reached.
RS27 10 SHOT STRIP LOAD
POWER CATALOG LOAD CASE
LEVEL NUMBER COLOR COLOR
3 3RS27 Green Brass
4 4RS27 Yellow Brass
5 5RS27 Red Brass
Fasteners for the RA27
Fastener Series Description
Max. Length
1500 Series .0300" head, 0.145" shank dia. 1-1/2"
1500SD Series .0300" head w/ 7/8" washer, 0.145" shank 2"
SP Series .0300" head, 0.150" shank dia. 1-1/4"
TE Series .0320" head, 0.157" shank dia. 1-1/4"
SDC/SPC Clips .0300" head ceiling clip assembly 1-1/4"
Fasteners for the RA27MAG
TE__X Series .0320" head, 0.157" shank collated in 1-1/4"
white colored strip of 10
Maximum fastener length for the RA27 is 1-1/2 inches. Contact Technical Support for
other fasteners that may fit in the tool.