RA27 SERVICE
BACK END / ADVANCE LEVER
7. When removing the Swivel Hook,
note that there is a small spring
that fits over the post on the hook
and is contained in the rear
handle grip
8. Remove the Strip Compartment.
This has a small amount of spring
pressure behind it from the
Trigger Spring. Slightly push
down and maneuver the
Compartment from the orange
housing. Next remove the
Trigger Spring from the backside
of the trigger.
9. Before removing the Mech.
Housing Assembly, take note of
the position of the Releaser,
Releaser Spring and position of
other components in the back
end.
10. The Mech. Housing Assembly
can now be removed from the
tool housing as a complete
assembly. Pull the trigger as you
normally would to fire the tool.
This will push the Mech. Housing
Assembly back to where it can be
removed from the tool.
