Filters and Battery Contacts
Cleaning the filters and battery contacts on a regular
basis will help make your tool work more efficiently.
To clean the filters
• Remove the cover and the filters.
• Lightly tap the filters to remove any dust.
• Replace the filters if damaged.
• Replace the filters and the cover.
To clean the battery contacts
• Periodically wipe contacts with a dry, soft cloth.
• Should they show corrosion, clean with a piece of
very fine emery cloth and clean with a dry cloth.
TROUBLESHOOTING
Tool does not work
- LED light is off
- No battery in tool
- Install battery
- LED flashes red
- Battery completely discharged
- Charge battery
Fan is on but the
tool does not fire
- LED is red
- Battery power is too low
- Recharge battery
- LED is green
- Fuel cell is exhausted
- Put in new fuel cell
Fan stops after the
- Call your local distributor for service
trigger is pulled
and LED is green
Tool firing is not
- Fuel cell is exhausted
- Put in a new fuel cell
consistent and
LED is green
Fasteners are not
- Fuel cell is exhausted
- Put in a new fuel cell
completely set
- Filters are too dirty
- Clean/replace filters
- Base material is too hard
- Consult distributor
Tool makes
- Consult your local distributor
low sound
- piston stays down
- no fastening made
- LED is green
Tool is sluggish and
- Filters are too dirty
- Clean/replace filters
overheats
SERVICING/TROUBLESHOOTING
SERVICING/TROUBLESHOOTING
14
FOR SERVICING REQUIRED BUT NOT LISTED IN THIS MANUAL,
PLEASE CONTACT YOUR LOCAL DISTRIBUTOR
