RAMSET FrameBoss pat003, Инструкция по эксплуатации

Страница: 13 / 28

Frame Boss
™
Instruction Manual
Trouble Shooting
Most commonly, problems are caused by over driving due to poor fastener or charge selection. It is wise
to consider these two factors as the first options in trouble shooting.
PrObLEM
Fastener over driven
Fastener under driven
Rough action
Reduction or loss of power
Tool misfire
Do not remove the tool
from the work surface
for at least 10 seconds
Tool Jam
Cartridge strip does not
index in tool
Cartridge strip melts
Cartridge falls out of the strip
LIKELY CAUSE(S)
Too much power
Fastener too short
Too little power
Fastener too long
Excessive carbon build up
Piston not returning to position
Faulty piston circlip
Build up of dirt in tool
Broken piston
Failure of tool to depress
completely
Cartridge strip damaged
Problem with tool, or faulty
charge / power load
Damage to power load chamber
Cartridge strip damaged
Strip index mechanism damaged
Tool overheated - fastening rate
too high
“Hot” tool compressed for too
long
ACTIOn
Use a low strength power load
or use the power adjustment
feature if applicable
Select the correct fastener
Use a higher strength power
load or use the power
adjustment feature if applicable
Select the correct fastener
Pull down, clean and lightly oil
tool
Check the length of the piston
Return Spring (Refer to page 13)
Remove piston. Replace piston
circlip
Clean tool parts
Replace piston
Disassemble tool and check all
parts for correct assembly after
first removing the power loads
Remove and replace with new
cartridge strip
Refer to page 5
Refer to page 5
Refer to page 5
Refer to page 5
Allow the tool to cool.
Disassemble tool to increase
rate of cooling. (p13)
Reduce fastening rate
Compress tool for a shorter
period of time
11