TOOL OPERATING INSTRUCTIONS
TOOL OPERATING INSTRUCTIONS
10
4. Hold the tool perpendicular (90°) to
the work surface with both hands
and press firmly to fully depress the
tool. Maintain firm downward
pressure on the tool with both
hands and pull the trigger to drive
the fastener.
DO NOT DEPRESS
THE TOOL AGAINST ANYTHING
OTHER THAN THE INTENDED
WORK SURFACE.
Holding the tool
firmly in place will produce more
consistent fastening quality and
minimize tool wear or damage.
6. After making the fastening, fully
open and then close the tool to the
semi-closed position. This resets
the piston and indexes a new load
into place for the next fastening.
7. Insert another fastener in the
muzzle end of the tool as before
and the tool is ready for the next
fastening. Keep your finger off of the
trigger until the tool is in position to
drive the fastener.
8. To remove a used or partially used
load strip from the tool, pull the strip
out from the top of the tool. Do not
try to remove the strip by pulling
it out from the bottom of the handle.
NEVER
try to remove a jammed or
stuck load strip that contains
unfired loads. Should a “jammed”
load strip occur, call your local
Authorized Ramset Distributor for
technical assistance.
HOLD THE TOOL FIRMLY AND
PERPENDICULAR TO THE
WORK SURFACE
FULLY OPEN THE TOOL AND
THEN CLOSE IT TO THE
SEMI-CLOSED POSITION
INSERT THE NEXT
FASTENER
REMOVE THE LOAD STRIP
ONLY FROM THE TOP OF THE
TOOL
