--CONTROLS---------------
LIFT CONTROL LEVER - FIGURE 3
The outside control lever located on the left hand side
controls the lift. Pushing the lever forward lowers the
lift arm and pulling the lever back raised the lift arm. In
these two positions, the lever is spring centered to
neutral upon release of the lever.
AUXILIARY CONTROL LEVER - FIGURE 3
The auxiliary control lever is located on the top and
between the main levers and can be used to control
accessory attachments such as; post hole augers,
trenchers, rock hammers, etc. Accessory hydraulic
hoses are connected to the quick couplers at the front
of the machine. Pushing the auxiliary lever ahead puts
the attachment in forward motion and pulling it back
reverses the motion. The lever is not spring centered
and must be returned to neutral manually.
TILT CONTROL LEVER - FIGURE 3
The inside control lever located on the left hand side
controls the tilting action of attachments such as
buckets, forks, etc. Pulling the lever back tilts the
attachment back. The lever is spring centered to
neutral upon release.
IMPORTANT
Ensure That The Auxiliary Lever Is Kept In
Neutral When Not Being Used To A void
Wasting Power. Engine Is Difficult To Start If
Lever Is Engaged. Hydraulic Oil May Also
Overheat
ATTACHMENT LOCK PINS
ATTACHMENT LOCK PINS
The "Taskmaster" tool bar design allows changing
from one attachment to another quickly and easily,
without having to remove pins.
Attachments are secured on the unit with two spring
loaded pins. Rotating the handles on the pins one
half of a turn moves the pins from the locked to the
unlocked position.
To
unlock
attachments, rotate both pins so that their
handles are both pointing to the
outside
of the tool
bar, as shown in
Figure 5.
To
lock
attachments, rotate both pins inwards so that
both handles are pointing towards the
center
of the
machine as shown in
Figure 6.
This will allow the
springs to push the pins downwards through the
mounting holes in the attachment and secure it to the
unit.
WARNING
The design of the quick attach system is such
that attachments can be lifted and carried
without the lock pins being engaged. Before
using any attachment, check to be sure that
the lock pins are fully engaged and properly
in place. The attachment will fall off when
dumped in the lock pins are not engaged,
resulting in possible damage or injury.
JULY 1998
- 6 -
LOCK PINS DISENGAGED
FIGURE 5
LOCK PINS ENGAGED
FIGURE 6
WARNING
After Hook-Up To Attachment, Check To Be
Sure Lock Pins Are Fully Engaged, And
Locked Into Position.
RAMROD TASKMASTER
Содержание MINI SKID TASKMASTER Series
Страница 2: ......
Страница 18: ...MAINTENANCE ASSEMBLY DIAGRAM FIGURE 21 J J f 1___ d 1 JULY 1998 _ r f I 14 RAMRODTASKMASTER...
Страница 21: ...MAINTENANCE JULY 1998 I I I N o FIGURE 22 17 RAMROD TASKMASTER...
Страница 37: ......