RAMROD MINI SKID 550T, Руководство оператора

Страница: 27 / 37

-- MAINTENANCE
HYDRAULIC/HYDROSTATIC SYSTEM MAINTENANCE
NOTE: Remove the plastic front cover for access.
HYDRAULIC
OIL FILTER
HYDRAULIC OIL
OIL DRAIN
BATTERY
.-
FIGURE 27
FIGURE 28
HYDRAULIC OIL
FILTER CAP
HYDRAULIC OIL LEVEL CHECK
1. Ensure that the Mini-Skid is standing level, the lift
arms are down and the tilt cylinder is closed.
2. Remove the oil cap, see Figure 27, and check
the level. If oil is apparent, the level is satisfactory.
3. If necessary, add the proper type and grade of
oil, until it appears at the check point.
CHANGING HYDRAULIC OIL
T he hydraulic oil normally needs to be changed after
1,000 operating hours or annually. However, if the oil
becomes contaminated, or a major repair has been
done to the hydrostatic transmission, it should be
changed at once.
1. Remove the oil drain plug. See Figure 28, and
drain a the oil. Remove the oil cap to ensure a
better flow .
2. Replace the oil drain plug, and refill reservoir with
clean oil of proper grade and type.
3. Start engine, and check for leaks. Stop engine
and re-check the oil level.
CHANGING HYDRAULIC OIL FILTER
1. With the. engine stopped, unscrew and remove
the old oil filter, see Figure 28.
2. Clean the oil filter mounting flange.
3. Apply a thin film of oil to the sealing ring and screw
the new filter into place. Hand-tighten the filter.
4. Start the engine and check for leaks. Stop the
engine, and check the hydraulic oil level.
IMPORTANT
Do Not Allow Dirt To Enter Into
The Hydraulic/Hydrostatic System
FINAL DRIVE MAINTENANCE
ADJUSTING NUTS
JULY 1998
- 23
DRIVE CHAIN
To obtain proper chain tension, adjust the 4 tensioning
nuts, (2 each side) to move the front axle forward or
backwards. See Figure 28.
RAMROD TASKMASTER