RAMROD MINI SKID 550T, Руководство оператора

Страница: 13 / 37

-- OPERATION
MOUNTING ATTACHMENTS
INSTALLATION OF ATTACHMENT
1 . Rotate lock pins to the unlocked position {handle
pointing outwards).
2. Tilt the attachment frame forward as shown in
Figure 7, so that the top round edge of the
attachment frame will fit under the lip on the
attachment.
3. Drive into the attachment, raising the arms so that
the top of the attachment frame slips under the lip
on the attachment, and attachment lifts slightly.
4. Using the tilt cylinder, roll back the attachment so
it drops into place, as shown in Figure 8.
5. Rotate the lock pins to the locked position
(handles facing inwards), and check that the lock
pins are fully inserted through the lock holes in
the attachment.
6. Connect attachment hydraulic hoses (if required)
to the quick couplers as shown in Figure 9.
& WARNING &
After Hook-Up To Attachment, Check
To Be Sure Lock Pins Are Fully
Engaged, And Locked Into Position.
REMOVAL OF ATTACHMENT
1. Lower lift arms and tilt forward on the attachment
so that the attachment is resting on the ground.
2. If attachment is hydraulically equipped, stop the
engine, relieve hydraulic pressure in the
attachment lines by shifting the auxiliary lever back
and forth, and disconnect the attachment
hydraulic hoses.
3. Rotate the lock pins to the unlocked (handles
pointing outwards) position.
4. Start engine, tilt the attachment forwards (dump)
until the top edge of the attachment mount frame
clears the lip on the attachment, and back the Mini­
Skid away from the attachment.
JULY 1998
- 9 -
FIGURE 7
FIGURE 8
FIGURE 9
RAMROD TASKMASTER