RAM TRX 2023, Руководство по функциям

Страница: 67 / 104

MULTIMEDIA 65

Prior to each event, verify the front and rear
brake pads have more than half pad thickness
remaining. If the brake pads require changing,
complete a brake burnish procedure prior to an
event at full pace.

At the conclusion of each event, it is recom -
mended that a brake bleed procedure is
performed to maintain the pedal feel and stop -
ping capability of your brake system.

It is recommended that each event outing
should end with a minimum of one cooldown lap
using minimal braking.

All vehicles are severe use tested for 24 hours
of endurance. However, it is recommended that
the suspension system, brake system, prop
shaft, and half shaft boots be checked for wear
or damage after every event.

Aggressive usage results in increased operating
temperatures of the engine, transmission, drive -
line, and brake system. This may affect Noise
Vibration Harshness (NVH) countermeasures of
your vehicle. New components may need to be
installed to return the system to the original
NVH performance.

Tire pressure:

Recommended tire pressure of 25 psi
(172 kPa) when tires are cold, or below
38 psi (262 kPa) when hot.
NOTE:
It is recommended that you target below 38 psi
(262 kPa) when tires are hot at the conclusion of
each session. Starting at 25 psi (172 kPa) cold and
adjusting based on ambient and conditions is
recommended. Tire pressure can be monitored via
the instrument cluster display and can assist with
adjustments.
V
ALET
M
ODE
To enter Valet Mode, press the Valet Mode button
from the All Profiles menu on the touchscreen. For
more information on Profiles, please refer to your
Uconnect Owner’s Manual Supplement.
While in Valet Mode, the following vehicle
configurations are set and locked to prevent
unauthorized modification:

Transmission upshifts earlier than normal.

Steering and Suspension are set to their Street
settings.

Steering wheel paddle shifters are disabled.

The ESC Off button is disabled.

The Launch Control button is disabled.

Engine power is reduced.
When the vehicle is started or was previously
placed in Valet Mode, a pop-up will display that the
vehicle is in Valet Mode. Select “Yes” to deactivate
valet mode. Alternatively, press the Locked Profile
icon in the Upper Status Bar to exit Valet Mode.
Enter your four-digit Valet Mode PIN and press
“Go”. Valet Mode will be deactivated. The
Uconnect system will load the last active Profile
before the vehicle was placed in Valet Mode.
NOTE:
If your four-digit PIN is lost or forgotten, the vehicle
will exit Valet Mode after a battery disconnect for
approximately five minutes. Reconnect the battery
and cycle the ignition to the ON/RUN position.
The vehicle will be in Auto Mode.
5
23_DT_TRX_SU_EN_USC_t.book Page 65