RAM TRX 2022, Руководство по функциям

Страница: 86 / 96

84 SERVICING AND MAINTENANCE
Cooling System — Drain, Flush And Refill
NOTE:
The intercooler must be vacuum flushed and filled.
If any coolant is needed to be added to the system
please contact a local authorized dealer.
F
USES
General Information
The fuses protect electrical systems against
excessive current.
When a device does not work, you must check the
fuse element inside the blade fuse for a break/
melt.
Also, please be aware that when using power
outlets for extended periods of time with the
engine off may result in vehicle battery discharge.
Auxiliary Switches — If Equipped
Four or six auxiliary switches may be located in the
lower switch bank of the instrument panel, and can
be used to power various electrical devices.
The functionality of the auxiliary switches can be
changed via the Uconnect Settings. All switches
can be configured for setting the switch type
operation to latching or momentary, power source
of either battery or ignition, and ability to hold last
state across key cycles.
Auxiliary Switch Location
NOTE:
Holding last state conditions are met when switch
type is set to “latching” and power source is set to
“ignition” within Uconnect Settings.
The auxiliary switches manage the relays that
power four or six blunt cut wires. These wires are
located under the hood to the right, near the
battery.
In addition to the four or six auxiliary switch wires,
a fused battery wire and ignition wire are also
found in this location.
A kit of splices and heat shrink tubing are provided
with the auxiliary switches to aid in the connection/
installation of your electrical devices.
WARNING!

When replacing a blown fuse, always use an
appropriate replacement fuse with the same
amp rating as the original fuse. Never replace
a fuse with another fuse of higher amp rating.
Never replace a blown fuse with metal wires or
any other material. Do not place a fuse inside
a circuit breaker cavity or vice versa. Failure to
use proper fuses may result in serious
personal injury, fire and/or property damage.

Before replacing a fuse, make sure that the
ignition is off and that all the other services
are switched off and/or disengaged.

If the replaced fuse blows again, contact an
authorized dealer.

If a general protection fuse for safety systems
(air bag system, braking system), power unit
systems (engine system, transmission
system) or steering system blows, contact an
authorized dealer.
CAUTION!
If it is necessary to wash the engine compart -
ment, take care not to directly hit the fuse box,
and the windshield wiper motors with water.
22_DT_TRX_SU_EN_USC_t.book Page 84