592 Incompatible component
Use a compatible display. If the problem persists,
con- tact your Raleigh Stride dealer.
605 Battery temperature error
The e-bike is outside of the permissible
temperature range. Switch off the system and allow
the drive unit to either cool down or heat up to the
permissible temperature range. Restart the system.
If the problem persists, contact your Raleigh Stride
dealer.
620 Charger error
Contact your Raleigh Stride dealer.
6 Brakes
Adapt your driving and speed to the weather and road conditions. In wet conditions
the performance of the brakes may reduce, and the braking distance may increase. If
you operate the front brake too heavy, this may lead to somersaulting. Therefore, we
strongly advise you to brake simultaneously via the left-hand and right-hand levers.
●
Use the left brake lever for the front wheel carefully at high speed.
●
Adapt the braking force to the riding situation.
●
Always brake simultaneously with both brakes.
●
Use the rear brake with care.
●
Incorrect brake pads may lead to reduced or increased brake performance or to
brake failure.
●
Only replace brake components with original spare parts.
●
Raleigh Stride is equipped with two disk brakes which take independent effect on
the front wheel and the rear wheel. Over a short braking distance, brake evenly with
both brakes.
Warning: If you notice that the effect of the brake is low, have the brake system
checked by a Raleigh Stride dealer.
6.1 Checking the brakes
Carry out the following instructions for the front wheel brake and the rear wheel
brake:
1.
Check that all the screws in the braking system are firmly screwed.
2.
Check whether the brake lever is torque-proof against the handlebar.
3.
Check whether there is still at le
ast 1 cm/0.4” of clearance between the brake
lever and the handle when the brake lever is fully deployed. If the clearance is
less than 1 cm/0.4”, have the brake system checked by a
Raleigh Stride dealer.
