5.3.4 Switching the push walking assistance on/off
The push walk assistance helps you to push your Raleigh Stride. The speed in this
function depends on the selected gear and can reach a maximum of 6 km/h. The
lower the selected gear, the lower the speed of the push walking assistance function
(at full power). The push walking assistance function must only be used when pushing
the Raleigh Stride. There is a risk of injury if the wheels of the Raleigh Stride are not in
contact with the ground while using the push walking assistance. To activate the push
walking assistance, briefly press the walk button (2) on your onboard computer. After
activation, press the + button within 3 s and keep it pressed.
Note: The push walking assistance cannot be activated at assistance level OFF. The
push walking assistance is switched off as soon as one of the following occurs:
●
You release the + button;
●
The wheels of the Raleigh Stride are locked (e.g., by applying the brakes or hitting
an obstacle);
●
The speed exceeds 6 km/h. The push assistance function is subject to local
regulations; the way it works may therefore differ from the description above, or the
function may even be deactivated completely.
Warning: Do not use the push walking assistance longer than necessary. By using it
for an unnecessary long term, the drive system might overheat.
5.3.5 Battery charge indicator
The battery charge indicator (g) displays the state of charge of the bike’s battery, not
t
hat of the onboard computer’s internal battery. The state of charge of the battery
can also be checked on the LEDs of the battery itself. Each bar of the battery symbol
on the indicator (g) represents approximately 20 % of the capacity:
The battery pack is fully charged.
The battery pack should be recharged.
The LEDs of the battery charge indicator on the battery go out.
Once the capacity for assisting the drive has been used up, the assistance is gently
switched off. The remaining capacity is still available for the lighting and the onboard
computer, the indicator flashes. The remaining capacity of the e-bike battery is
enough for about two hours of lighting. This does not account for other consumers
(e.g. automatic gearbox, charging external devices at the USB port). If the on-board
computer is removed from the holder (4), the last displayed state of charge of the
