Installing the RMR-VF
The RMR-VF requires an AC power adaptor and should be plugged directly into a 13A plug
using the supplied power adaptor.
NB
Two LEDs will light on the RMR-VF circuit board. The “Power” LED in the top left of the board
indicates that correct volts are being received from the power adaptor. The LED “D25” near the
terminal blocks shows that the RMR-VF on-board supplies are active (power to the terminal blocks).
Configure the RMR-VF using RASOFT Pro
For the RMR-VF to operate correctly with a RAKO system some initial setup must be
performed. This is done using a PC running RASOFT Pro (or Rasoft classic) software and
communicating via a RAKO Bridge or RAMPI programming device.
RMR-VF
Manual Version 2.0.0
