13
RainWise Multi Display Users Guide
2014 Revision
3)
Operating the Display
For a detailed explanation on each parameter display, refer to Section 1.4.
3.1)
Selecting Display Parameters
Pressing the button below a display will cycle through the available display options. The LED
next to the display will indicate the current selection. The scroll mode will cycle through these
selections automatically. Refer to Section 2.4 to set auto scroll.
3.2)
Turning Displays On and Off
Displays may be turned on or off independently.
•
Enter the Setup mode by pressing
MAX
then
SELECT
. The MAX and MIN LEDs
should be flashing.
•
Press
BRIGHTNESS
.
•
Each display will show either “on” or “oFF”.
•
To change a display’s status, press the button below the desired display (for example,
“TIME”.) This will toggle the status.
•
Press
SELECT
when done.
•
Press
SELECT
again to exit the setup mode.
3.3)
Displaying Minimums and Maximums
To display a maximum value, press
MAX,
then press the button below the desired display. The
maximum value will be displayed along with the date and time of occurrence. The “min” or
“max” of the current selection will be displayed. Ensure that the desired selection is being
displayed before doing the max/min sequence. If the window is scrolling, stop it by pressing the
button below the display before pressing
MAX.
3.4)
Resetting Minimums and Maximums
Minimum values are displayed in the same manner as the maximums. Maximums and
Minimums can be reset by pressing
SELECT
while a max or min is being displayed. The new
value will flash to indicate that it has been reset.